I am running Win 7 x64.  Just purchase a WET610N.  I am unable to run the CD that comes with it.  It start up then it just stop.  I came here and download the setup file, then I was able to run this set up to the point where it search for the WET610N.  I would get the error that it is unable to find the devices.

I am try to configure the WET610N using my Laptop so I can use it on my receiver and other devices.

Please any help would be greatly appreciated 

I did mention in my previous post that the included CD Set-up wizard is not compatible with Windows 7 although the WET610N Bridge itself is. I'm using Windows 7 (64bit) with the Linksys Cisco WET610N right now.

You are proceeding correctly, that's what I did. I used my Vista laptop to set-up the Bridge then just plugged it into my Windows 7 ethernet port. It really was very easy. I don't expect you'll have a problem.

The Setup disk which came along with WET610N is not compatible with Windows 7. You can try to configure the Bridge on a Different computer using the Setup disk or else you can configure all the settings on your Bridge Manually...

To Configure your Bridge Manually, Connect the Bridge to your Router using an Cat5 cable. Login to the Router setup page and check the IP address of the Bridge under the DHCP Client table List. Once you know the IP address of the Bridge and you can login to the setup page of the Bridge and make the change on it. The wireless settings on your Bridge should identical to your Routers wireless settings. 

Once you are done with the Settings, then you can unplug the Cat5 cable from the Bridge and then unplug the power from the Bridge, wait for 30seconds and re-connect the power to the Bridge and now your Bridge should be ready to Use.